EMBLITZ WinCE Hardware with ARM11

Source Code:WinCE 6.0

· Processor: Samsung S3C6410, ARM1176JZF-S, up to 667MHz.

· 128MB Mobile DDR SDRAM, 266MHz, Samsung K4X51163PC

· 256MB SLC NAND Flash, Samsung K2F2G08, 1G Nand Flash optional

· 2M Bytes NOR Flash, AMD AM29LV160DB

· 1 EEPROM, support I2C, it can be soldered with AT88SC016 for encryption

· SDIO WIFI Module, supporting IEEE802.11b/g

· LCD/Touch Screen interface. Supporting 3.5" TFT LCD, 4.3" TFT LCD,7" TFT LCD and 10.4" LCD (current stock is available with only 7” TFT touch screen display)

· Many modules are available for your choice- GPS, WIFI, Camera, USB HUB+4x4 Matrix Keyboard, USB 3G Modem.

· GPIO ,ADC, SPI,IIC, I/O, Interrupts and MMC are in 2 2x20 pin header

· One audio input interface (3.5mm audio jack)

· One 2-channel audio output interface (3.5mm audio jack)

· One 100M Ethernet interface (RJ45)

· One USB2.0 Host port (USB A/F type interface)

· One USB2.0 Device port (Mini USB type interface)

· Four serial ports (Two are five-wire interface, another two are three-wire TTL serial interface)

· 2 SD/MMC interface (supports 3.3V and 1.8V logic voltage)

· Camera interface (10x2 pins header, supporting the mode of ITU-R 601/656 8bit)

· One 5x2 pins JTAG interface

· Seven buttons (Reset, Boot, User defined, On/Off)

· One TVOUT

· Board Dimension: 116.6 x 76.8 x 17mm

· Power supply: +12

DOWNLAOD BROCHURE HERE